Device Setup and Installation
Hardware Requirements
What's in the Box
- Vojo Harvester
- Vojo Retina Sensor
- Sensor Cable
- Ethernet cable
- USB A to USB C cable
- Activation Code
Physical Installation
The Vojo Harvester should be installed on your digital display screen. Follow these steps to physically install the device:
Step 1: Attach the Vojo Retina Sensor
Position the Retina Sensor firmly against one of the four corners of the screen. Make sure it is placed on the active display area, not on the physical or digital bezel.
Step 2: Connect Ethernet Cables
Connect an Ethernet cable from the Harvester's left port to your network router or switch.
If you have a media player or digital signage device, connect it to the Harvester's right Ethernet port.
Step 3: Mount the Harvester
Mount the Harvester securely to the back of your display using the included Velcro strips. Ensure it is firmly attached and positioned to avoid strain on the cables.
Step 4: Connect the Retina Sensor to the Harvester
Connect the Retina Sensor to the connector cable.
Then attach the connector cable to the designated port on the Harvester.
Step 5: Powering the Vojo Harvester
Connect the USB-C power cable to the Harvester's power port and plug the other end into a USB power source, preferably an external power supply. Once connected, the Harvester will power up and begin its initialisation sequence automatically.
Next Steps
Once your Vojo Harvester is properly installed and configured, the next step is to register the device on the Vojo Portal.
Proceed to the Installation Guide to learn how to register your device and start monitoring your advertisements.
Continue to Installation